I’m printing directly on the build platform (V2) and am having trouble getting the height of the parts close to size. I started with the default settings and my part came out 0.9mm too high. I adjusted the z compression correction to 0.0mm and my part is still 0.2mm too high. How to I adjust it further to compensate? Also, how do I avoid the edge highlighted in the second image where the part sits on the build plate? Thanks. (I’m printing directly on the platform for speed of print and surfac
Glazing of 3D-Printed Silica to Reduce Surface Roughness and Permeability
Glazing of 3D-Printed Silica to Reduce Surface Roughness and Permeability
s41205-023-00197-5, PDF, Young's Modulus
Frontiers An Origami-Based Soft Robotic Actuator for Upper Gastrointestinal Endoscopic Applications
Prints resolution/distortion in area of supports and surfaces facing platform - Form 3/3+ - Formlabs Community Forum
Formlab 3 precision is worst than FDM - Form 3/3+ - Formlabs Community Forum
Formlab 3 precision is worst than FDM - Form 3/3+ - Formlabs Community Forum
First Layher Exceeding base Problem - Support & Troubleshooting - Formlabs Community Forum
Getting Started with 3D Printing: A Hands-on Guide to the Hardware, Software, and Services That Make the 3D Printing Ecosystem [2 ed.] 1680456431, 9781680456431
Glazing of 3D-Printed Silica to Reduce Surface Roughness and Permeability
